Can Present Sensor with Quick Connect NAQ3000-N03 Commonly referred to as "First

Commonly referred to as "First and Last can sensors"

A 13mm wrench can be placed on the flat sides of the standoff to help tighten it down

Bore Size: 125mm

This rail mounts to the exit end of the machine and is used to guide cans out Rinse Tunnel

For Hose ID: 3/4"

Can Present Sensor with Quick Connect NAQ3000-N03 Commonly referred to as "FirstThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.